Here are some universal multimeters

[shapanwwuopi]

Switch problems
For hand blenders
Often there can be problems related to the switch. If you try to use the switch on the blender and it does not work properly, you can check it with a volt-ohm meter. When you set the meter on the RX1 scale, it should show a low ready result. But if the reading is infinite, then the problem needs to be fixed or the switch may need to be replaced.

2. The knife shaft is jammed
Another common problem with hand blenders is the blade shaft jamming. In this case, you must disassemble the model until you can access it, then clean it of any debris or food particles that you may notice. Use white germany telegram data grease to lubricate rough areas if there are any. In most cases, the blade shaft jamming is caused by food particles, dust, and debris that are blocking the rotation path.

Image credits: Wikimedia Commons

3. The blender does not work
One of the most common problems with immersion blenders is that the blender does not work at all. This could be the result of a faulty fuse. To check the fuse, you may need to first disassemble the unit until you reach the inner housing where the fuse is located. Check this by disconnecting the wire connector that connects to the terminal box. This is where the fuse box and the power cord of your blender are located. Take a volt-ohm meter and attach its probes to both ends of the terminal box. Set it to the RX1 scale and then check the reading.If the reading is high, the fuse may need to be replaced.

4. Check the engine body and clean it.
There are other problems that can occur with immersion blenders. If you have followed the above repair methods, you can try another one. To do this, you need to open the housing with a screwdriver and clean all the contacts. Wipe them thoroughly and spray all the holes. Cleaning itself can help solve many problems. But if the problem is not solved, you may want to consider calling a professional for help.